ServicesBrandsService AreaAboutContactCall (888) 482-7007
Serving San FranciscoSan Francisco County

Dryer Repair in San Francisco, CA

The median San Francisco home dates to 1945, and in a house of that age the dryer vent is often the longest and most restricted part of the system. A dryer that runs hot or takes two cycles here is checked at the vent before anyone replaces a part.

Price in writing first
Warranty on parts and labor
Open 7 days, 6am to 12am
Technician holding the heating element removed from a front-load clothes dryer in a California laundry room
1 visitMost repairs finishedDryer
San Francisco Bay AreaOne number, one team
1 visit
Most repairs finished
No heat
Most common call
About half
Calls caused by the vent
7 days
Open
What it is telling you

What a dryer is telling you.

Runs, tumbles, no heat

On an electric dryer this is the heating element, the thermal fuse, the high limit thermostat or the cycling thermostat, in roughly that order. On a gas dryer it is the igniter, the gas valve coils or the flame sensor: the igniter glows, the valve never opens, the burner never lights. A blown thermal fuse is a symptom as much as a fault, because it blows when the dryer overheats, and a dryer overheats when it cannot exhaust.

Takes two cycles, clothes come out damp and hot

Airflow. The vent run behind the wall, up through the roof or across a long crawl space is restricted, the lint trap housing is packed, or the blower wheel is loose. The dryer makes heat and cannot get rid of the moisture, so it runs long, cooks the clothes and stresses every part in the heat circuit. Fixing the vent fixes the dryer, and it removes a real fire risk.

Squeal, thump, scrape or no tumble

A squeal that starts a few minutes into the cycle is an idler pulley or a drum roller with a dry bearing. A thump on each rotation is a flat spot on a roller or a damaged belt. A scrape is a drum glide or a bearing letting the drum ride on the cabinet. A motor that hums and will not turn the drum has a broken belt or a seized roller. All of these are single visit repairs.

Local conditions

The local conditions behind San Francisco dryer calls.

Vent runs in older San Francisco homes are long, and a lint-packed vent is the single most common reason a dryer here runs hot, takes two cycles or keeps blowing its thermal fuse. About 77.2 percent of homes here predate 1980, and the dryer vents in houses of that age are long, often rerouted, and packed with decades of lint, which is where the diagnosis starts.

What we repair

What we repair on dryers.

Gas, electric, stacked, compact and heat pump, every major brand.

  • Heating elements, thermal fuses, high limit and cycling thermostats
  • Gas igniters, gas valve coils, flame sensors and burner assemblies
  • Drum rollers, idler pulleys, belts, glides, bearings and felt seals
  • Drive motors, blower wheels and blower housings
  • Door switches, start switches, belt switches and moisture sensors
  • Control boards, timers, user interfaces and wiring harnesses
  • Heat pump dryer compressors, evaporators, pumps and filters
  • Dryer vent inspection, cleaning and repair of the run behind the machine
Straight pricing

What dryer repair costs in San Francisco.

Typical dryer repair price ranges by job
Typical jobWhat usually causes itTypical range
Runs but no heatThermal fuse, heating element, igniter or a blocked vent$140 to $380
Takes two cycles to dryRestricted vent run, cycling thermostat or a weak element$140 to $380
Squeal, thump or scrapeDrum rollers, idler pulley, belt or glides$140 to $380
Will not startDoor switch, start switch, thermal fuse or a belt switch$140 to $380
Stops mid cycleMoisture sensor, an overheating motor or a control fault$140 to $380

The diagnostic visit is $89. The whole repair is quoted in writing before any work, you approve it first, and the fee is credited to the job when you go ahead.

Straight numbers for San Francisco: $89 to diagnose, credited to the repair, and a typical dryer job between $140 and $380. Anything outside that range is quoted before the work, never after.

San Francisco dryer questions

What people here ask before they call.

The honest range for San Francisco is $140 to $380 for the common faults, and the $89 diagnostic fee comes off the repair when you approve it. Thermal fuses, thermostats, igniters, belts and drum rollers sit at the low end; a heating element, a gas valve coil set or a motor sits higher, and a control board is the top of the range. The quote comes first and it is the price you pay. Call (888) 482-7007; no heat, no tumble and a long cycle each point to a different part and a different number.

Yes for most of San Francisco. The technician who covers the San Francisco Bay Area runs the area every day, so a dryer call slots in without a long wait. The visit itself is short: a check of heat, airflow and the drive tells the technician what has failed, and fuses, thermostats, igniters, belts and rollers ride on the truck. Call (888) 482-7007 as early in the day as you can; morning calls almost always land a same-day slot in San Francisco.

Most dryers in San Francisco homes run twelve to fifteen years, and a machine with a clean vent reaches the top of that range. What shortens the life is heat it cannot get rid of: a lint-packed vent makes every cycle longer and hotter, and the fuse, the thermostat and eventually the element pay for it. Whatever the age, the question is the motor and the vent. Call (888) 482-7007 and a technician will tell you where yours stands.

Most of the time, yes. The dryers we condemn in San Francisco are the ones with a failed motor and a cracked drum on the same visit; everything else is a part. In older San Francisco homes the dryer hookup, the vent and sometimes the outlet were sized for the original machine, and a replacement can mean work behind the wall that a repair does not. Get the number first. Call (888) 482-7007, and if the repair is not worth it we will say so.

Yes, on parts and on the labor to fit them. That is standard on every San Francisco job and it is written on the quote. Genuine parts are part of the reason we can stand behind the work: an aftermarket element or igniter is where a repeat failure usually starts. It is one of the reasons to use a licensed technician in San Francisco rather than a handyman. Call (888) 482-7007.

Where we work

Dryer Repair across San Francisco.

Every part of San Francisco is in the dispatch area for dryer repair: 29 ZIP codes, one number.

9410294103941049410594107941089410994110941119411294114941159411694117941189412194122941239412494127941289412994130941319413294133941349414394158

Not sure if we reach you?

Tell us the cross street. We will tell you the time window in about ten seconds.

Call (888) 482-7007

Book dryer repair in San Francisco today.

Same-day slots go fast. One number, one team, the whole repair quoted first.

Call (888) 482-7007