Appliance Repair in Davis, CA
Davis runs on very hard water, and it shows up in the parts we replace: inlet valves, fill tubes, seals and heating elements. Same day in most of the city, and the price in writing before any work.
Every Davis ZIP code, one number.
Davis is a city of about 67,125 people in Yolo County. The housing is mixed, about 43.2 percent detached and the rest attached or multi-unit, with a median build year of 1983, so we carry parts for both full-size and compact appliances. Dispatch covers 3 delivery ZIP codes here, and the technician who comes out works Sacramento Region every day. Every delivery ZIP code in Davis is covered by the same number and the same team.
Not sure if we reach you?
Tell us the cross street. We will tell you the time window in about ten seconds.
Every major appliance, freestanding or built in.
Refrigerator & freezer
Not cooling, leaking, loud compressor, warm freezer. Freestanding, counter depth and built-in columns.
Washer
Will not spin, will not drain, leaking or walking. Hard water takes out the seals early here.
Dryer
No heat, endless cycles, thermal shutdown. Gas and electric, plus the vent run that causes half the calls.
Dishwasher
Not draining, not cleaning, leaking, stuck mid cycle. The number one hard-water casualty in the city.
Oven, range & cooktop
Burners that will not light, uneven baking, dead board. Gas, electric, induction and dual fuel.
Ice maker
No ice, slow ice, small hollow cubes, flooded bin. Almost always scale on the fill valve here.
Microwave & disposal
Built-in, drawer and over-range microwaves, jammed disposals, vent hoods and warming drawers.
SPECIALISTBuilt-in & luxury
Sub-Zero, Viking, Thermador, Wolf, Miele and Dacor. Assigned to a technician who has worked the platform.
What Davis repairs actually cost.
Nobody else on this search result will show you a number before you call. Here is the honest range, and what moves it.
| Typical Davis job | What usually causes it | Typical range |
|---|---|---|
| Dishwasher not draining or not cleaning | Scale on the inlet valve, a blocked sump or a tired drain pump | $150 to $400 |
| Ice maker not producing | Fill valve scaled shut, or a frozen fill tube | $150 to $380 |
| Refrigerator not cooling | Condenser fan, defrost system or a start relay | $180 to $480 |
| Dryer runs but will not heat | Element, thermal fuse or igniter | $140 to $380 |
| Washer will not drain | Drain pump, filter obstruction or the hose | $160 to $450 |
| Oven not heating evenly | Igniter, bake element or a calibration drift | $160 to $480 |
| Built-in refrigerator sealed system | Refrigerant charge, compressor or evaporator on a built-in | $800 to $2,200 |
One flat diagnostic fee of $89 gets a licensed technician to your door. The full repair is quoted before any work starts, you approve it first, and the diagnostic fee goes toward the job when you book the repair.
What people here ask us first.
Davis runs very hard water, and scale builds on whatever meets the water first. In a dishwasher that is the inlet valve, the spray arms and the heating element. In an ice maker it is the fill tube and the water valve. Scale narrows the opening water has to pass through, so the machine fills slowly or unevenly and the symptoms start looking electrical long before anything electrical has failed. Hardness is also far from uniform here. The city does not draw everything from one place, and readings run from around 4 grains in some parts of town to about 37 in others. Two homes a few miles apart can genuinely be on different water and scale up at different rates, which is why a neighbor's experience with the same model is not a reliable guide to yours. Age of the plumbing compounds it. About 46 percent of homes here predate 1980, and older supply lines and shutoffs hold scale that keeps feeding an appliance after the appliance itself has been cleaned up. What that means for the repair is that we check water pressure and fill volume before replacing anything. Swapping a control board on a scaled machine fixes nothing and costs a great deal more. The tell-tale is a dishwasher that stopped cleaning well long before it stopped running, or an ice maker turning out small, hollow cubes.
Seals and the heating element, earlier than the manual suggests. Davis water is very hard, and scale is abrasive. It works on the door seal and the pump seal every cycle until one of them starts weeping, which usually shows up as a damp patch under the front of the machine rather than an obvious leak. Detergent behaves differently in this water too, so people compensate by using more, and the excess suds leave residue that holds moisture against the seal and accelerates the same failure. Hardness is also far from uniform here. The city does not draw everything from one place, and readings run from around 4 grains in some parts of town to about 37 in others. Two homes a few miles apart can genuinely be on different water and scale up at different rates, which is why a neighbor's experience with the same model is not a reliable guide to yours. Age of the plumbing compounds it. About 46 percent of homes here predate 1980, and older supply lines and shutoffs hold scale that keeps feeding an appliance after the appliance itself has been cleaned up. A washer that will not spin or drain here is worth checking for scale at the pump before anyone condemns the motor or the board.
The oven will not heat, and behind that symptom the cause is almost always one part. On a gas oven it is the igniter, a small glowing element that has to reach a certain temperature to open the gas valve. As it ages it glows without getting hot enough, so the oven clicks or glows for minutes without lighting, or lights late and runs cool. On an electric oven it is the bake element, which burns through, sometimes with a visible break or a bright spot, leaving the oven cold or heating only from the broiler above. Both are inexpensive parts and short repairs, and between them they account for more oven calls than everything else combined.
The next tier is temperature: an oven that runs hot or cold, or bakes unevenly, is usually the temperature sensor, a calibration setting, or on convection ovens a fan that has stopped. Then doors: hinges and springs that let the door sag and leak heat, and gaskets that have torn. Then the self-clean casualties: a thermal fuse or a control board that did not survive the heat of a cleaning cycle, or a door that stayed locked afterward.
Expect $89 for the diagnostic visit, applied to the repair when you approve the quote. The igniter, the element and the sensor are tested before anyone talks about a board.
We also cover the rest of Sacramento Region.
Appliance down in Davis?
One call reaches a licensed technician near you. Same-day slots go fast.