Appliance Repair in Pomona, CA
Most Pomona appliance calls trace back to one thing: very hard water. Dishwashers, ice makers and washers meet it first. We diagnose for scale before we quote, which is why our repairs here tend to stay fixed.

What actually breaks appliances in Pomona.
The brand badge tells us less than the water, the air and the age of the house. This is what our technicians look for first.
Hard water
Pomona runs very hard water. Scale builds on whatever meets the water first: dishwasher inlet valves and spray arms, ice maker fill tubes, washer seals and heating elements. Hardness is also far from uniform here. The city does not draw everything from one place, and readings run from around 8 grains in some parts of town to about 21 in others. Two homes a few miles apart can genuinely be on different water and scale up at different rates, which is why a neighbor's experience with the same model is not a reliable guide to yours.
It is the most common root cause we find here, and the one most often misdiagnosed as a dead control board. Age of the plumbing compounds it. About 67 percent of homes here predate 1980, and older supply lines and shutoffs hold scale that keeps feeding an appliance after the appliance itself has been cleaned up.
Prewar and postwar stock
The median Pomona home dates to 1966, and 67 percent of the housing predates 1980. Kitchens of that era were built around appliances that are no longer standard sizes, on circuits that were never meant to carry a modern oven or a heat pump dryer.
The symptom is rarely a dead appliance. It is an intermittent one that trips under load, or a replacement that fouls the cabinet face.
All of Pomona, covered.
Pomona is a city of about 147,966 people in Los Angeles County. We run Los Angeles County as one dispatch area, and Pomona sits inside it with 4 delivery ZIP codes. One technician group covers all of Pomona; the ZIP codes below are the delivery areas we serve.
Not sure if we reach you?
Tell us the cross street. We will tell you the time window in about ten seconds.
Every major appliance, freestanding or built in.
Refrigerator & freezer
Not cooling, leaking, loud compressor, warm freezer. Freestanding, counter depth and built-in columns.
Washer
Will not spin, will not drain, leaking or walking. Hard water takes out the seals early here.
Dryer
No heat, endless cycles, thermal shutdown. Half the calls in older stock are the vent run, not the dryer.
Dishwasher
Not draining, not cleaning, leaking, stuck mid cycle. The number one hard-water casualty in the city.
Oven, range & cooktop
Burners that will not light, uneven baking, dead board. Gas, electric, induction and dual fuel.
Ice maker
No ice, slow ice, small hollow cubes, flooded bin. Almost always scale on the fill valve here.
Microwave & disposal
Built-in, drawer and over-range microwaves, jammed disposals, vent hoods and warming drawers.
SPECIALISTBuilt-in & luxury
Sub-Zero, Viking, Thermador, Wolf, Miele and Dacor. Assigned to a technician who has worked the platform.
What Pomona repairs actually cost.
Nobody else on this search result will show you a number before you call. Here is the honest range, and what moves it.
| Typical Pomona job | What usually causes it | Typical range |
|---|---|---|
| Dishwasher not draining or not cleaning | Scale on the inlet valve, a blocked sump or a tired drain pump | $150 to $400 |
| Ice maker not producing | Fill valve scaled shut, or a frozen fill tube | $150 to $380 |
| Refrigerator not cooling | Condenser fan, defrost system or a start relay | $180 to $480 |
| Dryer runs but will not heat | Element or thermal fuse, and very often a blocked vent run | $140 to $380 |
| Washer will not drain | Drain pump, filter obstruction or the hose | $160 to $450 |
| Oven not heating evenly | Igniter, bake element or a calibration drift | $160 to $480 |
| Built-in refrigerator sealed system | Refrigerant charge, compressor or evaporator on a built-in | $800 to $2,200 |
One flat diagnostic fee of $89 gets a licensed technician to your door. The full repair is quoted before any work starts, you approve it first, and the diagnostic fee goes toward the job when you book the repair.
What people here ask us first.
Pomona runs very hard water, and scale builds on whatever meets the water first. In a dishwasher that is the inlet valve, the spray arms and the heating element. In an ice maker it is the fill tube and the water valve. Scale narrows the opening water has to pass through, so the machine fills slowly or unevenly and the symptoms start looking electrical long before anything electrical has failed. Hardness is also far from uniform here. The city does not draw everything from one place, and readings run from around 8 grains in some parts of town to about 21 in others. Two homes a few miles apart can genuinely be on different water and scale up at different rates, which is why a neighbor's experience with the same model is not a reliable guide to yours. Age of the plumbing compounds it. About 67 percent of homes here predate 1980, and older supply lines and shutoffs hold scale that keeps feeding an appliance after the appliance itself has been cleaned up. What that means for the repair is that we check water pressure and fill volume before replacing anything. Swapping a control board on a scaled machine fixes nothing and costs a great deal more. The tell-tale is a dishwasher that stopped cleaning well long before it stopped running, or an ice maker turning out small, hollow cubes.
Seals and the heating element, earlier than the manual suggests. Pomona water is very hard, and scale is abrasive. It works on the door seal and the pump seal every cycle until one of them starts weeping, which usually shows up as a damp patch under the front of the machine rather than an obvious leak. Detergent behaves differently in this water too, so people compensate by using more, and the excess suds leave residue that holds moisture against the seal and accelerates the same failure. Hardness is also far from uniform here. The city does not draw everything from one place, and readings run from around 8 grains in some parts of town to about 21 in others. Two homes a few miles apart can genuinely be on different water and scale up at different rates, which is why a neighbor's experience with the same model is not a reliable guide to yours. Age of the plumbing compounds it. About 67 percent of homes here predate 1980, and older supply lines and shutoffs hold scale that keeps feeding an appliance after the appliance itself has been cleaned up. A washer that will not spin or drain here is worth checking for scale at the pump before anyone condemns the motor or the board.
Fit and power, before anything mechanical. The median Pomona home dates to 1966, and 67 percent of the housing stock predates 1980, so a lot of kitchens here were built around appliances that are no longer standard sizes. A replacement that is nominally the same width can still foul the cabinet face, the counter overhang or the door swing. Older circuits are the other half of it. A kitchen wired for the appliances of that era often cannot carry what a modern oven or a heat pump dryer wants, and the symptom is not a dead appliance but an intermittent one that trips under load. Parts availability matters too, since a discontinued board on a well-built older unit can be the difference between a sensible repair and a replacement. We check the opening and the circuit before quoting, because finding out afterwards is how a repair turns into a remodel. It matters more here because about 60.5 percent of homes here are detached single family.
The straight answer is a range per appliance, and the ranges are for typical completed repairs, parts and labor together, after the diagnostic fee has been applied. Refrigerators run about $180 to $480. Freezers about $160 to $420. Dishwashers about $150 to $400. Washers about $160 to $450 and dryers about $140 to $380. Ovens, ranges and cooktops about $160 to $480, and built-in microwaves about $140 to $360. The jobs that sit above those ranges are a short and well-known list: sealed-system work on a refrigerator, a drum bearing on a front-load washer, the compressor in a heat pump dryer, a replacement glass top, and the power board on an induction cooktop. If your fault is one of those, the technician will say so before quoting.
Reading the quote is as important as the number. It should be written, it should cover the whole job to a working appliance, and the invoice afterward should split parts from labor so you can see what you paid for. You can ask for the replaced parts to be handed back, which is the simplest way to confirm the part on the bill is the part that was changed.
Our diagnostic visit is $89, credited to the repair when you go ahead, and there is no hourly rate on top of anything above.
We also cover the rest of Los Angeles County.
Appliance down in Pomona?
One call reaches a licensed technician near you. Same-day slots go fast.